- Product Includes: DJI Inspire 1, Transmitter, Intelligent Flight Battery, 4 propellers, Battery Charger, 32gb Micro SD card
- Capture 4K Video and 12MP Stills
- 3-Axis Gimbal Stabilizes Camera
- Retractable Carbon Fiber Arms
- Unobstructed 360° Shooting
Fully charging the Inspire 1 remote controller takes approximately 6 hours. It can be used for approximately 4 hours after being fully charged.
No more than 6 slave remote controllers (3 for Japan version) can be connected at the same time. The primary slave remote controller will be able to change the camera settings, as well as the tilt and yaw of the gimbal. The other slave remote controllers can only be used to change the parameters of the camera.
The Inspire 1’s camera has only a very minimal “fisheye” effect, especially when compared to other flying platforms. Dedicated lens profiles for Adobe products such as Photoshop or After Effects will be released soon. Note: The focal length of the Inspire 1 lens is equivalent to 20mm.
Yes. Just press and hold your finger on the Camera page of the GO app for a few seconds. A circle will appear, which can then be dragged to adjust the orientation of the camera.
4K video generates 450MB per minute. At this rate, a 16GB SD card can hold up to 36 minutes of footage
Press and hold the circular power button for 5 seconds to check the battery life. The Battery Level Indicators will light up and/or blink for 10 seconds. Remaining battery life is also displayed in the DJI Pilot app.
After prolonged use, the internal charge indicator thresholds can become less accurate. Performing a full charge/discharge cycle can re-calibrate the charging parameters and extend the life of the battery.
Photos are available when a mobile device is paired with the master remote controller and can be downloaded to the device.
Yes, all Inspire 1 units come with standard TB47 charger. With the standard TB47 100W charger, it takes 85 minutes to fully charge a 4500mAh battery.
You can follow these steps to check the status of the battery:
The steps below detail if the transformation system is active:
The steps below outline what should be inspected:
Follow these steps to check if the motor housing needs replacement:
Here are some steps to see if your propellers are still manageable:
These two steps will instruct you if you need to calibrate your IMU:
This is how you inspect the CVTS:
Follow these steps to ensure proper gimbal and camera functionality:
The steps below will ensure that the VPS is active: